Tag Archives: Toasted Nuts

Apple Cider Sourdough with Roasted Ground Pecans and Walnuts

15 Nov

Fresh-milled Stardust WW, Spelt, and Danko Rye. Milled in my Mockmill 200 and mixed with my Ankarsrum. Open-baked with steam.

The spelt and rye were milled twice and not sifted. The Stardust was sifted with a #30 drum sieve and re-milled at the finest setting.

The nuts were finely ground in my mini food processor and toasted in a dry frying pan before adding to the dough.

The crumb is flavorful and fairly open. You can really taste the nuts, and they go great with the apple cider.

Formula

Levain Directions 

Mix all the levain ingredients together for about 1 minute and cover.

Let it sit at room temperature (I used my proofer set at 75°F) for around 5-7 hours or until the starter has almost doubled. I like to use the starter as soon as it has peaked.

 Prepare the Nuts

Measure the nuts and pulse them in a food processor, or if you don’t have one, you can chop them by hand until they are very fine, almost like nut meal. Toast them in a frying pan for several minutes on medium heat until you can start to smell them toasting. Be careful not to overdo it and burn them. Let them cool completely before adding to the dough.

 Main Dough Procedure

Note: I use an Ankarsrum Mixer, so my mixing order is slightly different from that of a KitchenAid or other mixer. Add all the apple cider to your mixing bowl, reserving about 1/4 to add later. Add all the flour to the bowl and mix on low for 1 minute, until it forms a shaggy mass. Cover the mixing bowl and let it rest for 25 minutes.   Next, add the levain, sour cream, and most of the remaining cider (as needed), and mix on medium-low speed (about speed 4) for around 15 minutes. Let it rest for another 20-25 minutes. Now add the salt and the remaining cider if needed, and mix on speed 4-5 until you have a nicely developed, smooth dough. Now, add all of the nuts and mix until fully incorporated. Don’t be afraid to mix longer. I have found that upfront gluten development is key if you want a nice open crumb.

Remove the dough from the bowl and place it in a lightly oiled bowl or proofing container, and do several stretch and folds.  Make sure the dough is as flat as possible in your bowl/container, and measure the dough in millimeters and take the temperature of the dough. Based on the chart from http://www.thesourdoughjourney.com, determine what % rise you need and make a note. If you have a proofer, decide what temperature you want to set it at and what rise you are aiming for.

Do a set of coil folds after 30 minutes, a second one 30 minutes later, and then one set of stretch and folds 30 minutes later. It’s important to build the layers of gases by doing the coil folds.

Once the dough reaches the desired bulk rise, pre-shape and let rest for 15-20 minutes. (Note: the % rise amount is a guide and with experience you will be able to tell when your dough has finished the initial bulk. You should see nice bubbly dough on the bottom and sides, and the dough should be jiggly). Finish shaping and place the dough in your banneton, bowl, or on a sheet pan, then cover it to keep it airtight.

When you are ready to bake, preheat your oven to 500°F an hour beforehand and prepare for steam. When ready to bake, score as desired. Prepare your oven for steam. I have a heavy-duty baking pan on the bottom rack, with 1 baking stone above it and another on the top shelf.  I pour 1 cup of boiling water into the pan right after I place the dough in the oven.  I then lower the oven temperature to 450°F and bake until they are nice and brown, and the internal temperature is at least 205 – 210°F.

Take the bread(s) out of the oven when done and let them (it), cool on a baker’s rack for as long as you can resist.